Wuxi City speech machinery Manufacturing Co., Ltd

0510-83218211

liyanjx8@126.com

750 cross shafts
750 cross shafts
750 cross shafts

Different from the drive shaft , 750 cross shaft shaft and bearing wear, from the use of point of view should not exceed 0.02 ~ 0.13mm, generally maintained at about 0.01mm. If more than 0.13mm, it produces the drive shaft shaking and the phenomenon of the ring, if the cross shaft shaft wear out the slot, the groove should be very deep repair or replacement. If the use of surfacing and set of repair, but also for heat treatment and grinding. After processing requirements of the journal non-roundness of 0.01mm, the taper can not be large (20mm length can not be greater than 0.01mm). To check the verticality of adjacent two axes, be sure to ensure vertical. After machining the axis of the journal should be in the same plane.


Previous: Cross shaft

下一条: XL star coupling